Configure trays
By default, the product pulls paper from Tray 1. If Tray 1 is empty, the product pulls paper from Tray 2,
or Tray 3 if it installed. Configuring the tray on this product changes the heat and speed settings to
obtain the best print quality for the type of paper that you are using. If you are using special paper for
all or most print jobs on the product, change this default setting on the product.
The following table lists possible ways you can use the tray settings to meet your printing needs.
Paper use
Configure the product
Load Tray 1 and one other tray with the
same paper, and have the product pick
paper from one tray if the other one is
empty.
Load paper in Tray 1. No configuration
is needed, if the default settings for type
and size have not been changed.
From the software program, print the
job.
Occasionally use special paper, such as
heavy paper or letterhead, from a tray
that usually contains plain paper.
Load special paper in Tray 1.
From the software program print dialog,
chose the paper type that matches the
special paper loaded in the tray before
sending the print job.
Frequently use special paper, such as
heavy paper or letterhead, from one
tray.
Load special paper in Tray 1, and
configure the tray for the paper type.
From the software program print dialog,
chose the paper type that matches the
special paper loaded in the tray before
sending the print job.
Configure trays
1.
Make sure the product is turned on.
2.
Perform one of the following tasks:
●
Control panel: Open the System Setup menu, and open the Paper Setup menu.
Select the tray that you want to configure.
●
Embedded Web server: Click the Settings tab, and then click Paper Handling in the
left panel.
3.
Change the desired tray setting, and then press
OK
or click
Apply
.
60
Chapter 6 Paper and print media
ENWW